Creating a Floor plan, Footing detail and Isometric view using AutoCad
AIM:- To create a floor plan,footing detail and isometric view using AutoCAD PROCEDURE:- Step 1:- Units are set to metre (m) limits and limax are used Zoom command is also used Snap and grid spacing of 0.5 unit is used Grid snap is rectangular and isometric snap Step 2:- Command:- Line Specify first point:-1,1…
Sandeep Ghosh
updated on 15 Aug 2021
AIM:- To create a floor plan,footing detail and isometric view using AutoCAD
PROCEDURE:-
Step 1:- Units are set to metre (m)
limits and limax are used
Zoom command is also used
Snap and grid spacing of 0.5 unit is used
Grid snap is rectangular and isometric snap
Step 2:-
Command:- Line
Specify first point:-1,1
Specify next point:-@4.87,0
Specify next point:-@0,9.47
Specify next point:-@-4.87,0
Specify next point:-close
Command:-Offset
Specify offset distance:-0.23
Select point on side to offset:-Select 4 corner of the side of the object
Draw bedroom,kitchen,dining,toilet,living room etc are used by using command offset,line,trim and arc
Typical isolated footing are shown by using command line,trim,offset,fillet etc
Typical isometric plan of wall are as given below
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by Sandeep Ghosh (41)
Week 1 Challenge
1. 1. Write the steps involved to upload a .std file through web mail? 2. Name the different materials that can be designed using STAAD Pro. 3. Is it possible to capture images in STAAD Pro? If yes how? 4. Name the three ways by which you can create a model. 5. Write…
19 Dec 2022 05:41 PM IST
Foundation Design using SAFE
1.Model the isolated footing provided in week 11 challenge on SAFE. Analyze and design it to verify the size, depth and steel provided as per calculations. AIM:- To model the isolated footing by using SAFE and to analyze and to design it to verify the size, depth and calculation of steel provided INTRODUCTION:-…
14 Oct 2022 03:42 AM IST
Design of Shallow Foundation (Isolated Footings)
1. Design a square footing for a column size of 400x400. The compression axial load for the load combination of (1.5 DL + 1.5 LL) is 2000 KN. The safe soil bearing capacity is 150 KN/m2 at a depth of 2 meters below E.G.L. Participants are free to go for either a tapered or stepped footing. Besides the total axial load,…
08 Oct 2022 06:08 PM IST
Structural Modelling using Etabs 2018
` 1. The architectural drawings for a G+7 residential building in zone 5 has been provided. The floor plan is the same for all 7 floor levels. Possible column positions have also been provided. Conceptualize a framing plan layout and then model the building in Etabs. The following architectural drawings have been provided:…
06 Oct 2022 11:13 AM IST
Related Courses
0 Hours of Content
