All Courses
All Courses
SKETCHER WORKBENCH OBJECTIVE: To create 2D Sketches in CATIA while following the necessary guidelines. MAIN REPORT: 1. DRAWING ONE: SKETCH'S IDEA: PART MADE IN CATIA: VIEW OUTSIDE THE "Sketch Mode": TREE STRUCTURE WITH GEOMETRICAL SETS AND CONSTRAINTS: …
Sagar Biswas
updated on 14 Nov 2022
SKETCHER WORKBENCH
OBJECTIVE: To create 2D Sketches in CATIA while following the necessary guidelines.
MAIN REPORT:
1. DRAWING ONE:
SKETCH'S IDEA:
PART MADE IN CATIA:
VIEW OUTSIDE THE "Sketch Mode":
TREE STRUCTURE WITH GEOMETRICAL SETS AND CONSTRAINTS:
FREEHAND SKETCH:
2. COMPULSORY DRAWING:
SKETCH'S IDEA:
PART MADE IN CATIA:
VIEW OUTSIDE THE "Sketch Mode":
TREE STRUCTURE WITH GEOMETRICAL SETS AND CONSTRAINTS:
FREEHAND SKETCH:
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
A pillar Design with Master Section
OBJECTIVE: To create the A-Pillar's Plastic component from the given Class A Surface using the Master Section that is provided while following all the design rules. INTRODUCTION: Types of Pillars and their importance in the Automotive Industry:- These pillars standing at the vertical or near-vertical…
16 Feb 2023 04:08 PM IST
Coin Holder Design
OBJECTIVE: To create the Coin Holder's Plastic component using the Class A Surface that is provided. Firstly, we have to create the required Tooling-Axis for the given Class A Surface while meeting the requirements of the necessary Draft Angle & then perform the Draft-Analysis Operation…
14 Feb 2023 09:08 AM IST
Bumper Design
OBJECTIVE: To create the Bumper's Plastic-Component using the Class A Surface that is provided. Desired Thickness of the Plastic Component is 3mm with 3 degrees as the Draft Angle. Firstly, we have to create the required Tooling-Axis for the given Class A Surface while meeting the requirements…
10 Jan 2023 09:15 AM IST
Base Bracket Design
OBJECTIVE: To create the Base-Bracket's Plastic Component using the Class A Surface that is provided. Firstly, we have to create the required Tooling-Axis for the given Class A Surface while meeting the requirements of the necessary Draft Angle & then perform the Draft-Analysis Operation on the…
10 Jan 2023 09:15 AM IST
Related Courses