MBD Simulation on a Piston Assembly (Multibody Dynamics using Solidworks)

Aim- The aim of this project is to perform a frequency analysis on a rotating shaft, from there we need to determine the critical frequencies and the mode shapes. 5 Mode Shapes were simulated and analyzed. Introduction:- Frequency is the number of occurrences of a repeating event per unit of time. The formula…

AIM: To create a basic 'RANKINE CYCLE SIMULATOR'. THEORY: The Rankine cycle is the fundamental operating cycle of all power plants where an operating fluid is continuously evaporated and condensed. The selection of operating fluid depends mainly on the available temperature range. The above figure shows us the basic rankine…

AIM: To write a program to fit a linear and cubic polynomial for the specific heat data set then calculate the goodness of fit using different parameters and different ways to improve the fit in MATLAB THEORY: Curve fitting is the process of constructing a curve or mathematical function that best fits the data points,…

Aim: To solves the ODE which represents the equation of motion of a simple pendulum with damping. Objective:  To write a program that solves the following ODE which represents the equation of motion of a simple pendulum with damping and create an animated video of output obtains by solving this ODE.   Theory:…