All Courses
All Courses
aim - Calculate the Wheel Arch gap at required points and check whether the car passes the European standard. Fender Fender is a part of an automobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent…
Sumit Nema
updated on 04 Nov 2022
aim - Calculate the Wheel Arch gap at required points and check whether the car passes the European standard.
Fender
Fender is a part of an automobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Fenders are typically rigid and can be damaged by contact with the road surface.
The main purpose of fenders on cars is that they shield the wheels and they protect the passengers, the pedestrians, and the other vehicles from stones, mud, liquid, and other debris that can fly in the air because of the speeding rotating wheels while the car is running.
Wheel Arch
Fender Wheel Arch Regulations
Japan Regulations
European Regulations
US Regulations
Clearance Obtained -0.114mm
AT SE SECTION
Clearance Obtained -5.988mm
AT SD SECTION
Clearance Obtained -2.879mm
AT SB SECTION
Clearance Obtained 10mm
AT SA SECTION
Clearance Obtained 10mm
Here, the negative sign indicates that the wheel arch is out of fender.
Hence by looking at the results obtained above, it can be concluded that the car will not pass the required standards in Europian Region.
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Project - Analysis of a practical automotive wiring circuit
1. Identify each of the major elements in the above automotive wiring diagram. Answer - The major elements are, Battery Generator Distributor Ammeter Fuse Ground/Earth Indicating Light/Beam light Starter Breaker Horn Light Switch/Selector Switch Junction Block 2.Explain the purpose and working of any three elements…
29 Dec 2022 06:33 PM IST
Week 14 challenge
Objective: The objective of this project is to design the assembly of the Butterfly valve and apply the GD&T concepts to the various parts of the Butterfly Valve. Name of the Parts: 1. Body 2. Shaft-Stem 3. Top Flange 4. Disc Plate 5. Lever Handle 6. Nut Introduction -A Butterfly valve is a quarter-turn rotational…
25 Dec 2022 06:38 PM IST
Project 2
AIM:- Route the Wiring harness on Given car body and Prepare flatten view drawing in CATIA V5. Application of all Packaging rules, Industry best practices studied in this course shall be demonstrated in design. Apply Protection coverings as required. Available connector 3D data can be used, or you can download the connectors…
15 Dec 2022 11:44 AM IST
Project 1
AIM- To route the wiring harness on given Engine and flatten view drawing in CATIA V5. OBJECTIVE- The objective of the project is to route the wiring harness on given Bugatti V16 Engine and prepare flatten view drawing in CATIA V5. All types of packaging rules have to be considered while routing the harness.…
14 Dec 2022 07:41 AM IST
Related Courses
0 Hours of Content