Fender Design - Wheel Arch Challenge
Report On Clearance Check for Front Fender And Wheel To The European Regulation. For the European regulations These four points should dear a safety gap of 10mm. The points will be at 1st at 30 deg forward from the wheel center on wheel outer dia 2nd at 50 deg rearword. 3rd at 150mm above wheel center, intersecting at…
VIKAS BISWAS
updated on 21 Feb 2022
Report On
Clearance Check for Front Fender And Wheel To The European Regulation.
For the European regulations
These four points should dear a safety gap of 10mm.
The points will be at
1st at 30 deg forward from the wheel center on wheel outer dia
2nd at 50 deg rearword.
3rd at 150mm above wheel center, intersecting at wheel outer dia.
And 4th at bisecting last two points on the wheel outer dia.
Projecting outer surfaces of fender and wheelon the top plane
At first point there is a gap of 10mm.
At second, third and fourth points there's a gap less than 10mm Le.. 2.4mm, 1.4mm and 0.43mm respectively.
For the European regulations there should be minimum gap of 10mm at these points. conclusion for this report is, this design does not satisfy the European regulations.
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by VIKAS BISWAS (27)
Design of backdoor
AUTOMOTIVE DESIGN OF CAR BACK DOOR USING NX CAD OBJECTIVE: i) From the given styling surface, develop a back door using appropriate design methodologies. ii) The objective of this project is to design a BIW Back Door of a car with an Inner Panel, Outer Panel, and Reinforcements for the Hinges, Gas stay, Wiper Motor, and…
21 Mar 2022 07:23 AM IST
Roof challenge
Roof Design: This report is about the roof design done with respect to the inputs like styling surface, master sections of various parts, design parameters, and andards used. Objectives: Create a Car Roof model based on the styling surface, master sections given for various parts with mastic points and reinforcements.…
11 Mar 2022 07:56 AM IST
Fender Design Challenge
Introduction: A fender is the curved portion of the car's body that sits over and houses the wheels. The purpose of a fender is pretty simple. Its purpose is to keep mud, rocks, and other road debris from being thrown around by the tires. In other words, the fender is a housing for the wheels that keeps road debris contained.…
28 Feb 2022 09:30 AM IST
Section Modulus calculation and optimization
OBJECTIVE: To increase the Section Modulus of the hood by necessary changes using NX cad. SECTION MODULUS: It is termed as the ratio of the second moment of area and distance from N.A (Neutral axis) to the extreme fiber. Also, it is the measure of the strength of the given member. The stress in the outermost section of…
23 Feb 2022 06:01 AM IST
Related Courses
