Creating 3D Isometric view of various structural elements in AutoCAD
Aim of the project: To draw the given drawingss in 3d along with the given sections with appropriate dimensions. The drawing in the project is done with help of AUTOCAD 3d software. Procedure: Step 1: The units of the drawing sheet is set to Engineering precision. Step 2: Construction line in horizontal…
Syed yaqoob Ali
updated on 19 Nov 2022
Aim of the project: To draw the given drawingss in 3d along with the given sections with appropriate dimensions.
The drawing in the project is done with help of AUTOCAD 3d software.
Procedure:
Step 1: The units of the drawing sheet is set to Engineering precision.
Step 2: Construction line in horizontal and vertical direction are drawn using the command ‘XL- h’ and ‘XL-v’
Step 3: A corner is created by trimming the bottom and left side of the construction line using the trim command: ‘TRIM’
Step 4: after drawings are created, page is set to 3d modelling, home tab is clicked.
Step 5: with the help of extrude command various extrusions are created.
Step 6: Then rendering is done as per the requirement.
Step 7: Similarly offset lines are created based on the room size and dimensions mentioned in the plan.
Step 8: drawings are saved in various viewports.
Results Obtained:
The drawing presented in this project contain 3d models of given plans and section. The dimensions of the rooms are mentioned with different layer options. screenshots and files are attached for your reference.
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by Syed yaqoob Ali (14)
3D Creation of Celing, Roof, Architectural plan, Structural plan, Sectional view, Elevation view and Camera specific view for a house plan using REVIT
AIM- to carryout various projects from q1 to q10 as given above using revit software and its various tools like ceiling, roofs, multiple views, project information, architectural and structural plan etc and execute the same PROCEURE: 1) Based on the project saved from Week 3, proceed from the First Floor Level.…
09 Jan 2023 02:39 PM IST
Project 2_Creating a 3D rendered model for a Residential Building in AutoCad
Aim of the project :- To draw the 3D residential building and to create the rendered view Introduction :- The general commands used for drawing the building is as follows : Line Polygon Rectangle Circle Erase Copy Trim Offset Extend Move Rotate Dimension Text Fillet Extrude 3D Rotate Etc The drawing in the…
19 Nov 2022 03:44 PM IST
Creating 3D Isometric view of various structural elements in AutoCAD
Aim of the project: To draw the given drawingss in 3d along with the given sections with appropriate dimensions. The drawing in the project is done with help of AUTOCAD 3d software. Procedure: Step 1: The units of the drawing sheet is set to Engineering precision. Step 2: Construction line in horizontal…
19 Nov 2022 05:25 AM IST
Creating various 3D Models like Furniture, Footing, Girder, Column drop with panel and Gable Wall in AutoCad
Q1) AIM : Create a 3D Furniture element as shown in the Figure. Assume dimensions which are missing. PROCEDURE : open the autocad ,and chanage the view cube to home in order to get 3d figure. invoke the line command by pressing l enter and draw a vertical line of 2'6 , followed by line of 3 feet in the next…
17 Nov 2022 09:16 AM IST
Related Courses
100 Hours of Content
