SURFACE MODELLING OF YACHT
SURFACE MODELING OF YACHT Objective: The objective of this project is used to create a surface model of different parts of the yatch using solidworks. To assemble the different parts modeled for the yatch. part modeling: part modeling you can create a part from a conceptual sketch through solid feature based modeling.as…
Kartik Patil
updated on 15 Jun 2020
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by Kartik Patil (12)
CRASH BOX SIMULATION USING LS DYNA
OBJECTIVE In this challenge we have to perform a simulation of crash box it similar to car carsh. but, here instead of car and their element there is box like structure. Here are the information about challenge - The crashbox should crash into a rigidwall created using *RIGIDWALL_ keyword. Check the manual to understand…
08 Nov 2022 04:09 AM IST
STRETCH RATIO CALCULATION BY COMPARING THE ELFORM (-2,-1,1,2) WITH OGDEN_MATERIAL MODEL. USING LS DYNA
OBJECTIVE To perform tensile test on a ogden material cubic block to calculate stretch ratio for different element formulation and to plot the stress vs stretch ratio plot and Compare the results for the simulation using ELFORM = 1, 2, -1, -2. PROCEDURE Create a block of 10mmx10mmx10mm dimension…
08 Nov 2022 04:07 AM IST
CONSISTENCY OF UNITS
Objective The objective of this challenge is to convert the given SI unit values of the given quantities to gm/mm/ms units and also to prepare consistent unit system table for different unit system. Value of the following measurements are given as follows: 1.MASS 1kg2.LENGTH 1m3.TIME 1s4.FORCE 1N5.STRESS…
08 Aug 2020 01:35 PM IST
MODELLING BEAM AND SOLID WELDSPOT AND CRASH TEST RESULTS ARE COMPARED USING LS DYNA
OBJECTIVE Modelling the beam and Solid spottweld for the plates and crash test result of axial and shear force should be compared among beam and solid elements. CAD MODEL The Cad Model Contains Two Parts Such As Uppar Part And Lower Part. They Are Not Connected Each Other In This Challenge We used Connect…
08 Aug 2020 01:24 PM IST
Related Courses
0 Hours of Content
