PHANI CHANDRA S
Mechanical Engineering Graduate
Skills Acquired at Skill-Lync :
- CFD
- NUMERICAL-ANALYSIS
- MATLAB
- OPENFOAM
- STRUCTURAL-MESHING
- ANSA
- ANSYS-FLUENT
- GT-POWER
Introduction
40 Projects
To mesh the IP substrate plastic component of an automobile using ANSA.
OBJECTIVE: To perform meshing for the IP substrate component with the given quality criteria using ANSA. PROCEDURE: 1. Geometry cleanup: First the model is imported to the ANSA software and checked for topological errors. These errors are rectified using some of the tools provided by ANSA which are: a) Faces -> New…
16 Jan 2020 12:17 PM IST
To mesh the plastic holder model using ANSA
OBJECTIVE: To mesh the plastic holder component for structural analysis using ANSA. PROCEDURE: 2.1 Geometry Cleanup: First the model is imported to the ANSA software and checked for topological errors. The model has no topological errors and hence we can proceed with extracting mid-surface. 2.2 Mid-surface extraction:…
15 Jan 2020 06:03 AM IST
Steady State Simulations to Compare the mixing effectiveness in Tee Geometry Using Ansys Fluent
AIM: To setup steady state simulations to compare the mixing effectiveness in Tee geometry. Case 1 Short mixing tee with hot inlet velocity of 3m/s Momentum ratio of 2 Case 2 Long mixing tee with hot inlet velocity of 3m/s Momentum ratio of 2 Case 3 Short mixing with hot inlet velocity of 3 m/s Momentum…
08 Feb 2020 07:17 AM IST
Discretization basics for range of dx
OBJECTIVE: To write a program that compares the first, second and fourth order approximations of the first derivative against the analytical or exact derivative with a varying value of dx. The function that is to be computed is f(x) = sin(x)/x^3 and the given value for x is x=pi/3. Numerical computation for first…
08 Feb 2020 06:38 AM IST
6 Course Certificates
Here are the courses that I have enrolled
Similar Profiles
Ladder of success cannot be climbed with hands in pocket.
The Future in Motion
The future in motion
Passionate to learn